simple a axis index mill not working

[shazam/TPP]

using x4 and a modified mpmaster post (also tried the mpmaster post same results) my a axis does not index correctly on the last toolpath and i receive errors when i post. i did the debug and can't seem to find what's wrong. i uploaded a zip2go file called "testing a" in the x4 file folder. first toolpath wpc is top and t/c is top, next wpc top and t/c front, next wpc is top and t/c bottom and last wpc top and t/c back. if i just selct first two it posts fine no errors, but select first three, i receive an error but code is good. when i select all four the last index position should be a270. but is a180. thanks all

[Josh Kinney -Elite Engineering]

You need to rotate the back view 180Deg on "Z".

[shazam/TPP]

Thanks but isn't that the point of using wpc set at top and the t/c set to back? it should set me at 270 degrees at that point?

[shazam/TPP]

BINGO +10000 Josh

 

took awhile to sink in what you meant.

i see why i was getting the error the bottom and back views are rotated 180 compared to the top and front view. so the post thought there was a b axis. thanks josh.

[Josh Kinney -Elite Engineering]

Glad to help