Viewsheets Not saving data in X4

[JLUSA]

Is anyone having problems with the viewsheets not saving WCS info. When in X4 I can create viewsheets with different T/C planes and it works fine. When I save the file and reopen it I lose all my T/C plane info. All the viewsheets have the same T/C planes assigned to them.

[3R!< W3NG3R]

I just tried it and it worked for me.

[JLUSA]

Well I uninstalled X4 and reinstalled it without migrating settings hoping that would help but it didn't. I also have X2 and X3 installed on my system. Would that make a difference. I wouldn't think so. I would really like to get it working for the simple fact that I do a lot of Horizontal programming. I am following the instructions from the manual and it just plain doesn't work fro me.

[3R!< W3NG3R]

Did you go into the settings and select all the options?

 

You can also set these in the config.

[JLUSA]

Yes I have done that and it still doesn't work. It will save the graphics view but not the T/C plane. I even went back to my original PC factory disk image and Installed X4 fresh and it still doesn't work. It will associate the correct T/C plane and Gview when I 1st create the bookmarks and as long as I am working on that file it works. As soon as I save it and reopen it loses The T/c planes.

[3R!< W3NG3R]

what about the 'automatic bookmark setting'

is that checked?

[JDowe]

Don't know if this is possible - but when I had

zone alarm on my system it interfered with

some Mastercam functions

[JLUSA]

Yes I have the automatic bookmark setting checked.

[JLUSA]

I don't have any antivirus or spy software installed on my system at this point. Only XP and X4 are installed.

[JLUSA]

Well I guess I figured out what was wrong. I had the automatically restore bookmark settings checked. It works backwards from my point of view. After I turned it off it works fine. I figured it would restore the settings back the way I set them up initially. It actually clears out the T/C planes. After turning it off I now open a file and my T/C Planes are set right.

[Josh Kinney -Elite Engineering]

Only problem is the view is now different. You can either have it clear the WCS after saving a file and keep your views correct or change your view every time you click on a different view sheet yet keep the WCS when saved. Hope this gets fixed in X5.