X4 MU1 Translate and rotate problems

[beck250]

Has anyone else had trouble with translating and or rotating after installing x4 mu1 update? It works for awhile then starts to leave random parts of the model behind and makes copies.

[mandolinkgn]

I am having the same issues with it.

KGN

[freza]

I have the same problem.

[beck250]

I did a clean install and that seemed to fix it so far.

[beck250]

It still does it sometimes after the clean install but is better than before, were it did it all the time.

[Kohler Joe]

What do you mean by clean install?

Thanks

[beck250]

I went to the tech tips on mastercam home page and selected I want to completely uninstall mastercamX.

[[email protected]]

I am having this issue in "Translate" but it "Rotates" fine

 

Anyone??

[[email protected]]

This is a bunch of F***ING S**T!!!! This is worse than the black verify BS. If I go back to x4 I prolly wont be able to open the files I've already saved in MU1

[The_Evil_Machinist]

Works fine here. Can I have more info on how to recreate it?

[[email protected]]

Try to rotate a solid model 90 degrees from the origin is all I'm trying to do.

[The_Evil_Machinist]

how big is the file?

[[email protected]]

Too big to mail, around 30ish Mb

[[email protected]]

I have an old solid that needs to be changed, so to save time (Boy was I wrong) I was gonna do a little "Presidential Engineering" if ya know what I mean, but now I have a clusterf**k.

[The_Evil_Machinist]

quote:

---

now I have a clusterf**k

---

.

So Do I. It's powered by apple

.

Ok I tried with some files that were 50Mb and up. I couldn't get it to do what your saying it's doing. Everything's behaving like it should on mine.

[[email protected]]

We have a customer that wants to run some old service parts. We have been making these molds for them for about 7 years and they have changed through the years so I was trying to rotate the old model 270 degrees to orient it like the current model and save the parting lines/sealoff area from the current model and cut the center section out of the old model and boolean add them together, which is no problem, I've done it in MCAM hundreds of times. But I simply can not rotate the old model (or the new one)it rotates some of it and leaves some of it not rotated

If I save as, and delete the toolpaths it will prolly knock it down to under 10Mb. If I send it to you will you simply rotate it 270 from the origin and send it back to me??

Thanks

[The_Evil_Machinist]

Sure send it to me. That way you can say you've been saved by a mac!

[[email protected]]

Thanks, I cut the center out of it to make it even smaller.

It's on the way

[The_Evil_Machinist]

clockwise or counter clockwise? around what axis?

[[email protected]]

Either -90 or +270 around the origin at the top WCS

Thanks again

[The_Evil_Machinist]

ya have mail! Praise my macs!

[[email protected]]

Thanks,

If I'm the only one having trouble with this, will it do any good to send it to QC?

[Leigh @ Kodiak]

Murray, were you rotating it using the old style rotate, or using dynamic xform?

[beck250]

Its caused by duplicate entitys in the model deleting them seems to cure it

[[email protected]]

I'll give that a shot, thanx beck

 

Leigh, not using dynamic, just xform, rotate