Mastercam & Vericut

[malo]

Hi

I am new in Vericut software.I need mastercam vericut interface.

I have mastercam X3 and vericut 6.0.3

I also i see the vericut forum and below like:

http://www.cgtech.com/forum/viewtopic.php?...mastercam#p2888

but there is not any file and that link doesn't work.

Please help me for vericut interface for Mastercam X3.

Thank you.

[Mgrenier]

Malo,

 

In the directory where Vericut is installed, you will find a windowsmcamv directory. Look there for the proper mastercam version and place the files where needed.

 

If not there, contact cgtech.

[Code_Breaker]

Keep in mind that Vericut 6.0.3 cannot do "multiple" setup from one file ... Multiple setups wasn't intoduced until 7.0.0 and MasterCAM interface would combined all multiple setups into the first WCS ... This was fixed in 7.0.3 ... If you are happy doing one setup at a time ... you are OK ... If you have more than one WCS, machine, etc. then you MUST go to 7.0.3 ...

 

HTH

[malo]

Thank you