Spaceball Drivers

[Larry Metzler]

I have just installed Mu3 for X4. I am using a 4000 FLX spaceball and it has stopped

working. It was working fine before the upgrade. The message states reload drivers. The drivers I have must be incomplete, As after reloading I get the same error. I cannot find drivers thru the internet. If anyone can steer me to a download site, or send me a copy of the drivers, it would be greatly appreciated. Thanks all.

[CADCAM3D5AXIS]

try this site

http://www.mindflux.com.au/products/spacetec/4000flx.html

[CADCAM3D5AXIS]

or

http://www.3dconnexion.com/service/drivers.html

[gcode]

Larry,

go to the Start/Exit page

of System Config and make sure

"Enable 3D Connexion Device" is checked

[Larry Metzler]

cadcam3d, Thanks for the info, drivers have been

reinstalled from your recommened site and it is now working fine.

gcode, also thanks for the input, 3d was enabled.

I cannot shout the praises of our forum members enough. I do not remember a problem we have had

that was not resolved in a timely and efficent

with the help of members.Thanks to all