X4 problem again

[PoNyCaR50L]

Since I bought my new PC with Win7 x64 I have problem with my master. I tried updating drivers, complete uninstall of X4 twice, ...

 

 

If I run X4 mu3, when I drag geometry or move something everything is slow, buggy.

 

If I install MU3, its running ok. .. anyone have any idea what happen?

 

and now, I cannot do a engraving toolpath, the windows dont appear and dont give me an error

 

Same thing with advance multiaxis!!! its a big problem for me now. the box open but if I click any toolpath like swarf, port or multisurface, the box close and no error appear.

 

any suggestion?

[gcode]

What video card are you running?

[PoNyCaR50L]

Quadro FX580

[gcode]

Try this..

Right Click your X4 desktop short cut

then click Compatibility

Check Disable Visual themes

and

Disable desktop compsitions

if that doesn't help..

Right Computer

then Properties

then Advanced Settings

then the Settings button in Performance

set the radio button for

Adjust for best performance

[PoNyCaR50L]

ok I found the problem for advance 5axis. the folder Chook was not link correctly.

 

I tried all the thing you said, but it dont help, same problem.

 

its just strang that if I install X4 without update it run good, but with update, everything become slow...

[JDowe]

I have some problems with the updates if the

computer has an AMD processor

[gcode]

quote:

---

the folder Chook was not link correctly.

---

did you drag your old config file

from one computer to another?

if so, your config file is bad.

close mastercam

delete your config file

restart mastercam..

when it can't find the old file

it will write a new one.