Bug, Lead In/Out, Adjust Start / End of contour

[Dave.L]

Anyone seen this but and know if it's reported?

 

I often use this feature for chamfering up to shoulders.

 

The values are not sticking.

 

WTF

[Leigh @ Kodiak]

I use this pretty regular, and have never had an issue, ever. Are you hitting the 'TAB' key after inputting your values?

[Dave.L]

I think I figured out what's going on.

 

I am pretty sure the value I am setting is too large and therefore it's only working on one side of the contour.

 

Sorry for the false WTF

[Thee Rickster ™]

[edited] for redundancy...

[Chris Parish]

Dave:

 

I believe there was something mentioned in the past about selecting the "apply" button as well that this corrects an issue

[Dave.L]

Chris,

 

I always hit the apply button. the value I was entering was too large.

[Joe788]

quote:

---

I often use this feature for chamfering up to shoulders.

---

I'd like to see a check surfaces function for chamfer routines. Just select the edge you want to chamfer, and then select any check surfaces you don't want the tool to hit. A function like that would have saved me 100+ hours last year.

[Dave.L]

quote:

---

I'd like to see a check surfaces function for chamfer routines. Just select the edge you want to chamfer, and then select any check surfaces you don't want the tool to hit. A function like that would have saved me 100+ hours last year.

---

Joe,

 

That is a cool idea. It would save the trial-backplot-error.

[Mic6]

quote:

---

It would save the trial-backplot-error

---

Your not kidding. Trying to keep .005 from a wall takes some backplot/verify time.