O/T Flames

[kccadcam]

Has anybody run across any GOOD graphics or .eps files of different types of flames?

I've been to www.ezflames.com but seems expensive.

[Scott Bond]

Good Question Kevin,I think we should have flames on everything.

I drew a few sets, it wasn't to dificult. I also

made my own BMX shirt grafics in mastercam that look more like flames on the track when the shirt moves,I'm wearing one in my profile picture.I have a few artist tricks, and maybe Bertua a few more,(IMHO) If you start something of what you want and post it , it will end up closer to what you want.

I looked at the EZFLAMES it's not such a bad deal, Do they come in any 2-d Iges format?

 

[ 02-03-2003, 08:59 PM: Message edited by: Scott Bond ]

[kccadcam]

I think they are only .eps (adobe) files.

Works great with engrave add-on in Mcam.

I downloaded a sample file from EZFlames and converted it in Mcam, came in great.

I'm looking for an eyeball with flames like

ezflames044 drawing on page 3 of samples in the online image viewer.

[kccadcam]

I've uploaded that sample conversion that I did under the MC9 dir.

 

engrave_flames.mc9

 

Came out pretty good for a few minutes of screwing around.

[cadcam]

Kevin how big is the file?

I have downloaded the file nad there seems to be no entities. It says the file is 41K.

 

I am going to try bring it down one more time.

[cadcam]

Ok you must of been uploading the file when I tred to get it.

Sorry.

[Scott Bond]

Hi Kevin

 

I alterede your file to show show simple 3-d flames for your part. See if you can veiw my cuts

in the MC Verify. This is the basic idea, I hope it helps.

[kccadcam]

Scott,

Did you just rotate the geo from the side?

That works pretty slick.

I'm still looking for more flames......

 

[cadcam]

Ok I foolowed scott and did one for my self please reveiw mine sir.

I will post a pic in a few min.

 

[ 02-17-2003, 04:18 PM: Message edited by: cadcam ]

[cadcam]

As I said I would.

Engraved flames

[kccadcam]

Jay,

This was done with the engraving add-on, right?

[cadcam]

Yes sir it was.

How do you like it?

[Toolfab]

Bad xxxx Jay, those are cool!