surfacing problem

[HEAVY METAL]

i have uploade a file to the ftp server 3dp.mc9 in the mcp folder .i'm trying to step that radius and angle down along wall .wall is about 10 deg angle. i have tried flow line ,contour and para.all paths don't look like the are machining correctly. any suggestions would be great

thanks hm

[Scott Reiner]

I tried changing 2 things in your toolpath, with good results, leaving more material on the check surfaces, .006 rather than .005 also filtering the toolpath. Your machine would have to support G18 arcs to filter this toolpath though. Also you probably won't require the end surfaces that you had set as checks. Like the wind.

 

Scott

[HEAVY METAL]

how do i climb cut on this surface

[cadcam]

Heavy Metal change the Machining angle to 180 this ill make it work fine I just got it to work here to.

Oh I forgote if you only want it to climb them you also need to set it for one along with the 180.

 

If you want to see the file I will load it up for you.

 

[ 02-10-2003, 01:10 PM: Message edited by: cadcam ]