DWG Help

[gms1]

Hello folks,

 

I just recieved a file from a customer and I cant convert it. Im using v 8.1.1 and it tells me that it only supports dwg v13-2000.

 

I uploaded the file "50328s1.dwg" to the ftp. Is it possible for someone here to convert it for me to a .mc8 file? I cant contact the customer and our salesman isnt here. Thanks in advance

 

[edit: im not sure if I am allowed to do this here, if not just delete the post and ill remove the file from the ftp]

 

Greg

 

[ 02-18-2003, 10:13 AM: Message edited by: gms1 ]

[cadcam]

Done,Look for your file under the MC8 folder.

[Philcott]

Jay,

Here I am thinking I can help since a lot of our forum buddies are blanketed inder a couple feet of snow. (I love the erie silence after a big dump of snow and the wind has calmed down) I convert file and start downloading, to your ftp site, and I am asked if I want to replace the file. Dam beat again. Kudos to your flying fingers.

 

Phil

[gms1]

Thanks a ton Jay!!

 

 

Greg

[cadcam]

Phil Its all in the thought.

But I am sure just like I would be is that you made the effort.

 

I am not alwas here so keep it coming.

[Fig sign]

You can download from internet IntelliCAD 2001 the Autocad clone free of charge .

In demo mode you will have the possibility to use it 1000 times .

You can open dwg from Autocad2000 and save it as dxf ver12 and use mastercam dxf convertor