Compare to STL Dialog Settings

[Code_Breaker]

In Verify, when using "Compare to STL file", the dialog box tolerance setting is defaulted to

 

+.01

+.005

+.001

 

-.001

-.005

-.01

-.02

 

I know I can change them on the fly, but I would like to change the default settings .... where?

 

Presently, in my config file, the Verify Settings are "Tool tolerance" .001 and "STL tolerance" is .001

... therefore the +.001 and -.001 is ALWAYS in violation ... when I set it to +.002 and -.002 I get what I want ... Every time I use this tool, I have to change the settings manually ...

 

I would rather change the defaults ...

[mchin-pilot]

I think same issue with assigning colors?, you can change on the fly but how you configure to stay permanent?

[Chris In-House Solutions]

Code Breaker to set your STL tolerance and Tool Tolerance Values go to Settings, Configuration and follow the picture.

 

mchin-pilot to set your colors for verify follow the same steps as above and under color settings pick the tool number then the color you want to appear.

[Code_Breaker]

"ding...ding...ding, wrong, but thanks for playing" (Dead Poet Society)

 

Code Breaker to set your STL tolerance and Tool Tolerance Values go to Settings, Configuration and follow the picture.

 

 

Chris,

 

Did you even read my post question? Your answer has nothing to do with my question .... in fact, I even address what you were talking about ... please try again

 

Presently, in my config file, the Verify Settings are "Tool tolerance" .001 and "STL tolerance" is .001

[Guest]

Don,

 

Unless I am mistaken, there is no way to change those defaults.

 

Nothing I have ever seen or run across

[Code_Breaker]

I figured that, since Tom said he did not know ... if he doesn't know ... no one knows