More g02 code with scallop

[wfcPain]

I'm cutting a frisbee looking part using scallop.

My surface was created in mastercam using surface revolve.

 

How would i get more G02 code output.My post has all x,y line segment moves.

 

Surface contour is a little better but does'nt maintain the stepover at the top.

I,ve tried high speed toolpaths and every setting i can think of.

 

My total tolerance is .0002 and i have "create arcs in xy",checked in line/arc filter settings.

 

Is there is post setting?

Any direction you can point me is appreciated.

[gcode]

turn on arcs in all three planes

 

the toolpath most likely to give you arcs is waterline or contour

[Roger Peterson]

two words

 

wireframe -> Swept 2D

 

or is that three words... or four...

 

 

Anyway use the geometry you used to create the surface to do a swept 2d toolpath and you will be very happy.