Middle Button Zoom Fit

[Newbeeee™]

Hi All,

Is there any way of mapping the middle mouse button (wheel) so that double clicking it makes mastercm zoom fit?

Autocad does this and I am so use to doing it...

Cheers

[mchin-pilot]

F1 or F2 does similar job.

 

You can definitly key them , but not the double click of mouse...

 

( The software writers can make anay button work as you ask, but do mastercam have to work like Autocad? )

 

Transition takes little time , after little extensive use of MC, you'll find it comfy doing cad in mastercam.

[Newbeeee™]

Thanks for the reply.

I have zoom fit on the right mouse button, and keymapped F1 for save, as it's next to escape which I use a lot

I know mcam doesn't have to be the same as autocad, but I just wondered if I could make this feature the same.

Cheers

[Lascelles]

Down load "X-mouse Button Control" from Majorgeeks.com (Free)

 

I mapped my wheel to "enter" and use the 3d mouse button for fit

[Newbeeee™]

Thanks for the reply.

I downloaded that and it's a neat bit of software.

No matter how I played with it, I couldn't get it to rotate with a click (std setting) and zoom fit with double click or dwell.

Pitty as this looked so promising.

Cheers

[HT]

You can program midle button left click or righ click to command Alt+F1 inside your mouse driver (Logitech or Microsoft)then one click to the left or one click to the right will give you zoom fit. I think it litle bit faster than double click .

[HT]

You can program midle button left click or righ click to command Alt+F1 inside your mouse driver (Logitech or Microsoft)then one click to the left or one click to the right will give you zoom fit. I think it litle bit faster than double click .