4 axis program help.

[cormigu]

Hi Guys,

I'm trying to make a program in a 4 axis but I don't now how, I wanna to use just one WCS (G54) and to get 0-90-180-270 deg ,is it possible?

 

thx.

SAMPLE PART.MCX-5

[CJep]

If you're using the MpMaster post you could activate mics integer #9 that will lock onto the work offset. The post will ignore Mcam trying tell to output multiple work offsets.

[cormigu]

I'm using GENERIC HAAS 4 -AXIS VMC.

 

THX.

[Guest]

I don't like your part setup for 1 reason I ALWAYS suggest if you do rotational work, set it up on the actual system axis it will be rotating about.

 

In this case this works, set all ops to 0 on the work origin, the rotate around the top

[cormigu]

I don't like your part setup for 1 reason I ALWAYS suggest if you do rotational work, set it up on the actual system axis it will be rotating about.

 

In this case this works, set all ops to 0 on the work origin, the rotate around the top

 

 

 

 

Oh OK thanks,but how can to get just G54 ( No G55 G56 57.....) and 0-90-180-270 deg.

 

thx.

[Guest]

set all ops to 0 on the work origin

 

Look at my work offsets, post it.

 

Then check my settings in the transform, its set to off

[cormigu]

Look at my work offsets, post it.

 

Then check my settings in the transform, its set to off

 

every is just fine but the issue or question i have is? how come when i post it to G codes ready to put it into the machine, all my work offsets are different according to the angle for example:

 

N1020 T9 M6

N1030 G0 G90 G54 X-2.25 Y0. A0. S4500 M3

N1040 G43 H9 Z.73

N1050 G99 G81 Z.2375 R.73 F30.

N1060 G80

N1070 G55 X-2.25 Y0. Z.73 A-90.

N1080 G99 G81 Z.2375 R.73 F30.

N1090 G80

N1100 G56 X-2.25 Y0. Z.73 A-180.

N1110 G99 G81 Z.2375 R.73 F30.

N1120 G80

N1130 G54 X-2.25 Y0. Z.73 A-270.

N1140 G99 G81 Z.2375 R.73 F30.

N1150 G80

N1160 M5

N1170 G91 G28 Z0.

N1180 A0.

N1190 M01

[Guest]

DOH!!!

 

in the transform, change it to maintain source operations

[K2csq7]

+1^

[cormigu]

DOH!!!

 

in the transform, change it to maintain source operations

 

Thanks a lot JParis,for your help,.....it's working fine......