punch out all programs on Fanuc 31i controls

[Ashan]

Please some one direct me how to send out all programs in oneshot to RS32 PORT ON

Fanuc 31i controls

THANKS

San

[jeff]

All of the Fanuc controls I've ran you just hit O-9999 then output, or send

 

Letter O not a 0

[Guest]

O-9999 Read will Read ALL

O-9999 Send will Send ALL

 

O-9999 Delete will Delete all, careful with those keystrokes

[Ashan]

1) I tried O-9999

IT doesn,t accept

 

2)

I tried O1 , O9999 and punch it

It doesn,t accept

3)

then I tried just puch out

it was fashing lsk

but no programs come out

 

 

for single program Oset enter and exeute

only works

 

thanks

[Manuel0822]

removed

[K2csq7]

+1 ^

Never done a batch punch like that, but I have always needed the letter O before the numbers...

[GIZMO 21]

how about if u try to send something from rage of O0001 to O7000

cause i just did that the other day,and i could't send O8000 an O9000

prog's cause the parameters for editing O8000 and O9000 prog's were locked.

i don't remember the parameters,but i unlocked that and all was good.

i hope this helps.

[jeff]

how about if u try to send something from rage of O0001 to O7000

cause i just did that the other day,and i could't send O8000 an O9000

prog's cause the parameters for editing O8000 and O9000 prog's were locked.

i don't remember the parameters,but i unlocked that and all was good.

i hope this helps.

 

doesn't matter if that parameter is on or not, the O-9999 works regardless of that and sends all programs.

[MikronGuy]

flashing LSK is the lead skip. that means it is trying to output the programs but the accepting device is not correct. your I/O value should be set based on the device your are sending to or receiving from. your Fanuc manual should have this info to change the value.

off the top of my head i can't recall which parameter controls this. maybe some one can chime in.

[Guest CNC Apps Guy 1]

You guys are so old school it cracks me up... O-xxxx ROFL

 

Ok, you want ALL the programs in ALL the folders on a 31i control... the easiest is to go to System, Maitnenance, right soft key until you see "ALL IO", press "ALL IO", then OPRT, and punch and execute.

 

HTH