Issues and features

[Guyinthedesert]

Guyinthedesert,

 

What post are you using? If it's a derivative from mpmaster, you can use Misc values, Mi9 is to lock on first WCS.

 

HTH

 

Thanks for the tip. The post I've used for years is based on Mpfan. I just tried it with Mpmaster and that works. So maybe it's time for a post overhaul.

[K2csq7]

So maybe it's time for a post overhaul.

 

No need for an overhaul....

 

comment out your pwcs postblock, then make a new one right below it....

#pwcs        	#G54+ coordinate setting at toolchange
 	if mi1$ > one,
   	[
   	sav_frc_wcs = force_wcs
   	if sub_level$ > 0, force_wcs = zero
   	if workofs$ <> prv_workofs$ | (force_wcs & toolchng),
     	[
     	if workofs$ < 6,
       	[
       	g_wcs = workofs$ + 54
       	*g_wcs
       	]
     	else,
       	[
       	p_wcs = workofs$ - five
       	"G54.1", *p_wcs
       	]
     	]
   	force_wcs = sav_frc_wcs
   	!workofs$
   	]

pwcs
 	"G54"

 

That works in one of mine

[Thee Rickster ™]

Back on topic for a minute, sorry.

 

I have the ability to copy a group of toolpaths to a new group and or even different file,

but no ability to change the steep/shallow using the new geometry in "change common parameters"

 

Would any body else find this usefull?

 

I would give Hardmill's left nut, if this was the only enhancement in X6.

[friggenbozo!]

Hi ,folx

 

Talking about MCX5 MU1

 

 

 

 

Talking about Dinamic area milling why I can not enter from any point i LIKE ?

 

 

 

I wonder if there's an offbeat solution to this? Like using a reference point at the wanted start position, or something like that???

[Teh Bear without Brains kinda idiot]

I wonder if there's an offbeat solution to this? Like using a reference point at the wanted start position, or something like that???

~~~~~~~~~~~~~~

No way as far as I know