Tool manager

[Dtm]

Is there any easy way to check if your tool #s H and Ds are all the same. When I go to the tool manager It shows the tool number and description, but does not show the diameter offset nor the length offset. I have been going through every tool to make sure they are the same and this can be very cumbersome. I was hoping there was an easier way rather than posting out the program and going through it.

[BrandonH]

I've often wished to be able to "H" and "D" values in the tool manager. Enhancement request?

[Zoober]

I just do a quick launch of my X+ setup sheet that shows my H and D numbers along with other info on my tool sheet:

 

[Dtm]

I just do a quick launch of my X+ setup sheet that shows my H and D numbers along with other info on my tool sheet:

 

 

Thanks. That works great. I don't use X+ much and didn't see you can add these iteams. This is going to save me alot of time.

[Newbeeee™]

+1^^^^^

It also is great for checking work offsets are correct and coolant on.

[Zoober]

Glad it worked for you.