2D Dynamic Restmill

[Fred @ Slate Industries]

Hi guys

The toolpath works great but goes to each corner pick out

Each Z pass.

Is there a way to have it clean out each corner one at a time ?

 

 

Thanks

Tony

[Millertime]

Look next to youre stock to leave params above that check optimize cuts within pocket

[Fred @ Slate Industries]

No change, it's either the tool stays down

 

Or it rapids up and over at each depth cut.

I used to use a insert mill the

Same size of the corner radius

And just use a drill cycle over on each corner center

Old school but FAST

[Millertime]

I didnt realize you were using depth of cuts.It woul be nice if under the depth of cuts setting you could pick by depth or by contour.just like on a standard 2d contour.

[huskermcdoogle]

I brought this one up a while back. No dice. Best thing you can do is do the extra work to chain the corners separately by getting your parameters the way you want. then copying and pasting the operation and masking out the all but the one you want to hit, until you have hit them all. Sucks, and is a lot of work, but you can get good results and still use the rest mill function with stock associations back to the original operation. If you need to rest mill again, then you would use stock model and optirest in the same manner so that you can use the stock model as the stock.

 

 

Husker