VERIFY SETTINGS

[TERRYH]

For MCX6 MU3 what are the best settings for the Moves/ step: and the Moves/ refresh: I typically run my slider all the way towards quality. see attached.

[Radical1]

It kind of all depends on the toolpath you are verifying. if its just a 2D then 1 and 1 is usually ok but if its a brutal 3D it may take a long time to verify so I usually use 100 and 1000. Make sure that you have stop on collision check marked so the verify stops in case of collision. It also depends on the graphics card you are running.

[?Mark]

10-10-max-max

 

If lots of surfacing I'll bump up steps to 50 or more...depending on the size, but always with the best quality.