X6 very strange warning

[Bill Henderson]

I have a program I wrote a few weeks back. At the time I ran verify and everything was fine...

 

However, today I opened the file and went to run verify and I got this message...

 

"you are accessing prototype functions...

 

something about beta test agreement...

 

I have done nothing new to this file or mastercam. I did however turn on the control panel so I could enable post debugging...

 

Could that have done it?

 

Thanks

[gcode]

Were you an X6 beta site..

I think early X6 betas had a UBVS beta and somehow that old warning is popping up????

[Guest]

In X6 the UBVS system was in but not defaulted, IIRC, if you turned it on, via the X utility, you would get dialog

[Bill Henderson]

You are correct John.

 

I went back into the utility and turned that off and the message went away.

 

thanks to both of you.