X7 MU1 Round Stock

[NOTW Programmer]

Am I the only one with this issue? Came in this morning and all of the sudden my Stock is sitting 1" above where it should. Perhaps its too early but here it is. Just for kicks I changed the TF001584-3 stock to round and it also moved but on X instead. Weird !

TF001585-2.MCX-7

TF001584-3.MCX-7

[crazy^millman]

-2 looks fine. -3 is not respecting the stock setup for Verify. You need ot change the process to cylinder and then also adjust the numbers then it is good to go. I would check your endmill length on the circle mill it hits your material in the Verify. I see -3 as a bug and suggest you report it to qc.

[MIKO ELLO]

I have the same problem. I am using round stock and when I go to verify then the stock is not in the right position.

[MrFish]

Am I the only one with this issue? Came in this morning and all of the sudden my Stock is sitting 1" above where it should. Perhaps its too early but here it is. Just for kicks I changed the TF001584-3 stock to round and it also moved but on X instead. Weird !

 

This is because you are using an non standard WCS in your stock setup - try changing your stock setup WCS plane to TOP and it works fine. This is a bug that I have reported to QC.

[NOTW Programmer]

This is because you are using an non standard WCS in your stock setup - try changing your stock setup WCS plane to TOP and it works fine. This is a bug that I have reported to QC.

Funny thing is that I use non-standard all the time and 90% of the time it works all the time !