Translating Entities

[guitar]

Frequently, when I try to translate/scale/offset/etc entities Mastercam does not move the entities unless I do a File reload. I have seen this on more than 1 pc. Anyone else have this issue?

 

Mcx7 mu1, windows X7.

[Thee Rickster ™]

Nope, but i suggest you upgrade to MU2.

[Matthew Hajicek - Singularity]

I remember that in X7. Been on X8 for a while and haven't seen it there.

[Brando]

with x7mu2 , ive had that happen with dynamic transform, and sometimes stuff dosent hide after i select entities to keep on the screen, it dont know why, i wont duplicate on the other programmers computer when he opens it,and hes had that happen on his as well but it wont duplicate when i open his ,

it happens on such a rare occasion, i dont spend hours to investigate why, i just work around it and move on

but you could try using the repaint screen(found under view), regenerate display list(found under screen) or the ram saver (under settings), those might work instead of reloading,

usually one of those three fixes it for that session and until i save\close\open it up again i dont have anymore problems

[guitar]

I remember that in X7. Been on X8 for a while and haven't seen it there.

 

Actually, that is where the problem started. When we went back to MU1 we still could not get rid of it.

[guitar]

with x7mu2 , ive had that happen with dynamic transform, and sometimes stuff dosent hide after i select entities to keep on the screen, it dont know why, i wont duplicate on the other programmers computer when he opens it,and hes had that happen on his as well but it wont duplicate when i open his ,

it happens on such a rare occasion, so i dont spend hours to investigate why, i just work around it and move on

but you could try using the repaint screen(found under view), regenerate display list(found under screen) or the ram saver (under settings), those might work instead of rebooting,

usually one of those three fixes it for that session and until i save\close\open it up again i dont have anymore problems

 

 

I don't actually reboot. I just reopen the file without closing mastercam and it goes away.

[Brando]

actually thats what i wanted to type, i stopped in the middle of that reply to talk to someone and i guess i forgot what i wanted to say exactly lol