Mori vs Mazak

[?Mark]

Hi Doug.

Yes, that's the one. And there is nothing wrong with NOT knowing the machine like that. The problem is not admitting it, playing wait game until warranty expires or blaming it on "crashes" that NEVER happened, lol.

We've been extremely careful with it. The operator finally managed to break a .750" rougher while cutting aluminium after almost 1.5 years of running it

[FROZEN]

Serious questions for you, have you looked into Okuma? We have quite a few customers in Mankato and south of the cities that will attest to the quality of our service department. We just finished install of an LB3000EX-MYW in Mankato yesterday and will be training all next week.

 

What Okuma is comparable to NTX2000 or I-200???

[Mr. M]

The Multus series would be the model line that you want to look at

[YoDoug®]

What Okuma is comparable to NTX2000 or I-200???

 

Multus U3000

 

[FROZEN]

The Multus series would be the model line that you want to look at

Does the Multus come with a lower turret???

[YoDoug®]

You can get it with or without lower turret, sub spindle or tailstock, 1000mm or 1500mm length.

[FROZEN]

Who sales them in the Mankato area???

[DUM1]

HAD A MAZAK INTEGREX THAT WENT THRU SPINDLES LIKE SOCKS NOT CHEAP!!! THE GOOD NEWS WAS IT ONLY HAPPEND WHEN YOU RAN THE MACHINE

[FROZEN]

Thanks for all your opinions

[HYPERTUNE]

I've had an NTX2000 for about 8 months and it has been flawless so far. Support from Mori and Esprit has been outstanding. 

 

The post might be locked, but it works.... There have been a couple of times where I thought a post edit would be nice, but each time 

I have been shown a way to get the code I want without needing a post edit. 

 

PM me if you have any questions.

[msmith9744]

 

We have 16 Mori's in our facility in Oklahoma. Most of them purchased in the 90's and still going strong.