In machine deburr issues

[RobRick]

Hoping someone can help me with this one. I need to program a deburr path on 2 diffrent part and am looking for a tool that I have used in the past but it's been years. It's a 90deg  dual faced chamfer tool , carbide that comes to almost a point. .1875 major cut diameter. It was used for edge break inside and outside of part features. I just can't remember where I got it or who made it. ( senility kicking in here ). Does anyone recognize this cutter? It is diamond shaped with a reduced neck with upper and lower cutting surfaces. Also if i do find what i'm looking for i will probably be asking for advise on making it do what I need it to do. LOL  Thanks Rob. 

[GIZMO 21]

if your talking about a double angle dovetail cutter, Harvey tool would be the place to look.

 

http://www.harveytool.com/prod/Double-Angle-Shank-Cutters/Specialty-Profiles/Browse-Our-Products_196/Double-Angle-Shank-Cutters_210.aspx

[specv]

Harvey or Micro 100 tools are great tools for this.

 

http://www.harveytool.com/ToolSearchResult.aspx?Criteria=CategoryName%3dDOUBLE+ANGLE+SHANK+CUTTERS

 

http://www.micro100.com/catalogs.htm

[RobRick]

Thank you Gizmo and specv. I found one that will probably work thru Harvey. Now I just have to make it do what i need it to do.
LOL. 

[Matthew Hajicek - Singularity]

I also use these once and a while:

 

http://www.harveytool.com/cat/Undercutting-End-Mills/Specialty-Profiles/Browse-Our-Products_192.aspx

[Mike-T]

+1000.. If the break though is reasonably flat.. the 90 deg woody works.. but if your trying to do cylinder to cylinder burr ball works best.