2017 Fillet Entities

[Leigh @ Kodiak]

It seems I can't fillet between anything that is not a line. Pretty sure this worked fine before Update 1,  but maybe it is just a setting I am somehow missing? You can see in the picture that the guidline says to select a line, whereas in X9 it says to select an entity. This works fine if I do a chain fillet.

Am I missing something? Is this a bug? Whats going on here?

 

 

EDIT: This has to be some sort of bug. After restarting 2017 I was able to use fillet Entities, although the preselection highlighting does not work on the arc, only on the line.

 

[Jayson Kramer]

it fully works it is not auto highlighting the two arcs that I just did a fillet between. but even when I added the line to an arc the line did not highlight either.

[Biggleboys]

it fully works it is not auto highlighting the two arcs that I just did a fillet between. but even when I added the line to an arc the line did not highlight either.

I didn't try adding the line but I'm having similar issues. Reminds me of my struggle with 3d printing. Hah!

[JoshC]

i just seen your post on the other forum and responded. turn your fillet to Normal, you probably have it set to relief which is why it wont select anything but lines.

[Biggleboys]

i just seen your post on the other forum and responded. turn your fillet to Normal, you probably have it set to relief which is why it wont select anything but lines.

That did the trick. Thanks a lot JoshC.