I need a scanned guitar neck converted please

[Guest]

I can't open these, I tried mx9 on both.

 

Are you running the HLE version?

[poolrod2]

Are you running the HLE version?

I don't think so, I work for The Boeing Company  using X9.

[Colin Gilchrist]

I don't think so, I work for The Boeing Company  using X9.

 

Which group? I worked in the Interiors Responsibility Center in Everett for about 5 years. I also did Mastercam Training for the guys at the Wind Tunnel, the Model Makers at Plant 2, and a bunch of the Emergent Machining guys in Auburn. I think the only group I didn't work with at some point was the 737 line in Renton.

[poolrod2]

Which group? I worked in the Interiors Responsibility Center in Everett for about 5 years. I also did Mastercam Training for the guys at the Wind Tunnel, the Model Makers at Plant 2, and a bunch of the Emergent Machining guys in Auburn. I think the only group I didn't work with at some point was the 737 line in Renton.

Hi Colin, I work in Emergent Operations in the 17-10 BLDG in Auburn. Small world,lol.

[#Rekd™]

I see you are asking the same questions on the NX Eng-Tips forum.

 

http://www.eng-tips.com/viewthread.cfm?qid=420160

[Newbeeee™]

I see you are asking the same questions on the NX Eng-Tips forum.

 

http://www.eng-tips.com/viewthread.cfm?qid=420160

Hahahaha - new avatar for Bubbles...