Translucency of solid

[RLeuschen]

It seemed that in previous versions you could select a specific solid (in an assembly) and change both the solid color and its translucent values. For some reason I seem to think that there was some sort of slide scale to adjust this translucency.

I'm in "View", "appearance". But when I drop the lower right corner all I get is a shading dialog.

Am I just in brain fog or is this possible in 2017 without going through the config every time?

Thanks

[Guest]

Brain fog....

 

Mastercam has never had the ability to have certain solids translucent while others are shaded

[RLeuschen]

That answers that... I hate when fog happens.

Next question, is there not a sliding scale for the translucency on the main bar somewhere? It just seems like a waste of time to run to the config settings every time.

[Fred @ Slate Industries]

SW has the some translucent some not

Photoshop has the slider for amount of opacity (sp)

 

You did see these option somewhere

Just not in MC

[jlw™]

Bottom right corner in 2017 is the toggle button.

[RLeuschen]

Thanks for the answers guys, all were correct.

I did find where I used it, we use to use Vero software, and that's where I found that.

Again... Thanks

[DUM1]

SETTINGS CONFIG SHADING??