Waterline not going to end of surface

[medaq]

Sorry stupid question of the day. I can not get this waterline surfaces to complete to the center. Leaves a weird gap. Even the tool starting is inside the surface. The surface has the same angle through out until the outside. Any ideas?

[Guest]

Try the Spiral path instead....or even the 3D Scallop in a spiral setting

 

Waterline doesn't like getting near flat....

[gcode]

Are you sure you don'the have a depth limit set

 

Also

 

Blend works very well for cuts like this

[Redfire427]

Check to make sure you don't have a value in the "skip pockets smaller than" field on the transitions tab. Also, check your depth values and also that your slope values are set from zero to 90 degrees of slope. That is a bit of an unusual move.

One other thought, make sure your lead-in/lead-out values are set to a fairly small number to see if the issue goes away.

 

Carmen