Active Reports Designer

[mrtqtr]

Hello there You create the same teams 3 times, can you help me please

[#Rekd™]

3 hours ago, Murat Kolik said:

Hello there You create the same teams 3 times, can you help me please

Have you tried asking your re-seller for help?

 

 

[mrtqtr]

yes but still no solution found. What else do you think can be done about it. I am sharing the attachment to you, I would be glad if you want to check the file. Thank you from now.

 

 

Reports.rar

[bydxcnc]

On 6/4/2020 at 11:19 PM, Goldorak said:

Exact

i want to avoid typing the setup sheet name each time 

Is there a solution to this problem?

[Aaron M]

How do you grab the Manual Entry operation by itself or is this even possible I want this to go to the comments section at the beginning of the set-up sheet. I am on master cam 2021

[Bill Craven]

If you create a manual entry as your first operation, If you run the MT setup sheet, the manual entry operations are posted to the Active Report.  (they may post out in Mill or Lathe also)

I use the MT setup sheet for everything.  It will post out Mill operations, Lathe operations, and Manual entries.  I have it color coded so that the different types of operations show up in different colors.

 

 

[nihart]

On 26.01.2021 at 11:44, mrtqtr said:

Merhabalar bazı düzenlemeler yaptım istediğim özellikleri oluşturdum fakat sadece ilk takım yolu bilgisi mevcut diğer programlar raporda gözükmüyor. Ne yapmalıyım? mastercam x8 kullanıyorum

 

 

murat kardesim merhabalar. sana yardımcı olmak isterim. 

mail adresime iletişim bilgini atarmısın.

[email protected]

[Akash Shukla]

Did not get the Toolpath NC File name in Setupsheet.

I have tried NCFILE-NAME   ,  NCIFILE-NAME 

Can you please help me out.

[cruzila]

TRY

NCFILE-SHORT

[Akash Shukla]

Hello ,

 

I wanted to know that what is correct data field of the pickup the nc file name in our setupsheet ,

 

I am trying with :-  NCFILE-NAME , NCIFILE-NAME.

 

But did not get any clear result ,

 

can anyone help me out .

[prado]

Boa Noite, não estou conseguindo fazer o marcador de pagina dar sequencia nas demais paginas, quando gero  a folha no rodapé mostra  PAGE 1 OF 2 porem a folha 2 não me mostra o numero da pagina, alguém poderia me ajudar ?

segue a imagem da folha que criei.