STK model chip removal

[AWL304]

Are there any tricks to removing "chips"  in your stk model display (inside mastercam not verify) from one operation to the next.

[Guest]

This issue doesn't come up often but in the times it has, I'll make a quick dummy toolpath to wipe away the remaining stock and ghost the path so as to not actually output while posting...

I know of no other way to do it with a stock model

 

[AWL304]

yep only way i know of as of now also, this particular part has some odd shapes being cut out and was trying to avoid the time in dummy toolpaths.

thanks

[crazy^millman]

5 hours ago, AWL304 said:

Are there any tricks to removing "chips"  in your stk model display (inside mastercam not verify) from one operation to the next.

Verify and then use the remove chips. Save out as an STL and go from there. You will have to do the Pmesh wash in Mastercam to get a non-hallow stock model, but once you do that wash you should be good to go.