12 min 2 sec ! Dell OPTIPLEX GX620 P4 at 3.00 GHz XP pro sp2 2 GB RAM

"Cross hatch: calculating cross hatch..." isn't fixed ! Try this(X2 MR2) in new file: Create -> circle Create->drafting->X-hatch Save ...Is OK! Now: Toolpath->contour (circle) Erase hatch Create->drafting->X-hatch Save ->..et voila !! The bug !!!! With another words: if the Operations manager is empty is OK !

quote: Please view the Whatsnew.htm file for detailed information on the bug fixes in the service pack. The "whatsnew.htm" file can be found in the documentation folder of your X2 installation. Isn't "whatsnew.htm" !! Is "ReadMe.htm" file... thanks anyway !!!

http://www.emastercam.com/ubb/ultimatebb.p...ic;f=1;t=021301 I hope this help !!

http://www.emastercam.com/ubb/ultimatebb.p...ic;f=1;t=021877

Is done !! It's in same place ...CONVERT.MCX

-------------------------------------------------Also, check your chains for duplicate entities. ------------------------------------------------- That was it ! Thanks a lot !

After when I use hatch in the screen remain a litle windows with this message: "cross hatch: calculating cross hatch..." I can't close it only if i restart mcam !! McamX MR2

Ok Pete, I'll wait fot MR2 final !!! Thank anyway !

JRauch, I use a Dell Optiplex GX620, P4, 3.0 Ghz, 1GB RAM

Nobody have already seen this problem ? CNC Software ? Forum administrator ?

I use Mill level 3 MR1 !

Hi, I try to modify a toolpath pocket standard with TOOLPATH EDITOR. I deleted same points and I moved a point. At end of that when I try to save Mastercam X ...CRASH !!...." the instruction at 0x0b3d2628 referenced memory at 0xb3d2628. The memory could not be read. Click on OK to terminate the programm". I try too with a simple pocket rectangle...same things. What it's this...? A bug ?

We will find it in MR2 ?

I find it !! In Rough(or finish) parameters->total tolerance->filter ratio 1:1, or 2:1 or 3:1 and tick Create ars in XY, XZ, YZ Thanks for help