There is a setting that you can change this value. Setting 22 CAN CYCLE DELTA Z This is a decimal numeric entry. It must be in the range of 0.0 to 29.9999 inches. This setting specifies the delta Z used in the G73 canned cycle when the Z-axis is moved up to clear chips.

That is a setting #85 and you can also adjust setting #191 to finish this can also be programmed with a G187 P3 E.010, G187 Setting the Smoothness Level (Group 00) G-187 is an accuracy command that can set and control both the smoothness and max corner rounding value when cutting a part. The format for using G187 is G187 Pn Ennnn. P Controls the smoothness level, P1(rough), P2(medium), or P3(finish). E Sets the max corner rounding value, temporarily overriding Setting 85 “Max Corner Rounding”. Setting 191 sets the default smoothness to the user specified “rough,” “medium,” or “finish” when G187 is not active. The “medium” setting is the factory default setting. NOTE: Changing setting 191 to “Finish” will take longer to machine a part. Use this setting only when needed for the best finish. G187 Pm Ennnn sets both the smoothness and max corner rounding value. G187 Pm sets the smoothness but leaves max corner rounding value at its current value. G187 Ennnn sets the max corner rounding but leaves smoothness at its current value. G187 by itself cancels the E value and sets smoothness to the default smoothness specified by Setting 191. G187 will be cancelled whenever “Reset” is pressed, M30 or M02 is executed, the end of program is reached, or E-stop is pressed.

One more thing to consider when changing setting #191 to rough is that this multiplies the value in setting #85 max corner rounding by four. G187 Pm Ennnn sets both the smoothness and max corner rounding value. G187 Pm sets the smoothness but leaves max corner rounding value at its current value. G187 Ennnn sets the max corner rounding but leaves smoothness at its current value. G187 by itself cancels the E value and sets smoothness to the default smoothness specified by Setting 191. G187 will be cancelled whenever “Reset” is pressed, M30 or M02 is executed, the end of program is reached, or E-stop is pressed.

gcode was right about the Haas control letting you chose between radius and diameter for the tool offsets. The control also lets you choose different options for tool offsets in this case you could choose tool lenght only and not put a value in the offset page. Are you using IPS or VQC for probing?

The platter on the TR-310 should be -.125 from the A axis center line but this should be verified because they do vary.