Wondered if anyone has any knowledge or experience with this company's die design software. The boss has already bought it, and it'll be here next week. Tell me your opinions!

This is pretty good, I agree, but not from Robin Williams. Truth or Fiction

I have also experienced this problem, but only when I tried to use both the standard stick font and true type font in the same drawing. If you use one or the other, it seems to be fine.

Where I used to work we would cut plywood on the Laser. Worked really well high feed, low power and nitrogen assist gas(high pressure) to choke out the flames. Just my .02......

Two websites come to mind that may help you out. Software & Logos HTH

If you are trying to figure out how many parts you can make from "said coil", I find it is easier to figure out the material needed to produce one part(i.e. L x W x T x density = part weight)....then find the weight of the coil. I will upload a spreadsheet to the FTP site.....(coil weight.xls). Hope this helps.... P.S. I use a density factor of .29 for steel and .1 for aluminum....

Just be glad you haven't suffered your whole life as a Lion's fan.

I think you just need to set your Tool Plane to Front. (Your tool plane should match your WCS) Hope this helps.