Thanks guys, I had a problem with my post. I was doing it write but we have a custom post that was putting the wrong sign

Ok that may help and thanks. Do I need to program my die section topside down? I am gonna be burning upside down. If so how do I flip my part over in mastercam?

Dang, I got older Agie machines. I am new to mastercam and on old software I set up my taper parameters on the machine. Not sure if I should even have to set it on mastercam but if I do not at this time, it does not put taper. If I do set taper parameters on mastercam it puts my land at the top of block no mater what I select. I prefer to burn taper jobs upside down as so that I can remove slugs with out moving the head

I burn taper blocks upside down and need help with parameters on taper page. I can not get my land to come out on top of block when burning upside down. any help is greatly appreciated

If you don't have a valve shut off I would just cut off the low pressure pump in the breaker box. What agie machine do you have?