Thanks Tim, Internet was down all afternoon. Russell

Would anyone know if on a Viper VTL with live Tooling and Fanuc Oi TD control, can and how would you orientate a C axis @ a certain position. We have flange with existing holes, need to set C axis to one of the holes and mill a slot with reference to this hole? Thank you for any comments Russell

view toolbar, toggle solid manager

You still can do perpendicular with an arc on the entry and exit, just put like a 20% arc @ say 90 deg. do a small perpendicular entry and exit like 20 or 30% and your comp will work

Think you should use Perpendicular lead in and out and you can still have an arc on entry and exit.

Why not consider like a Laguna router, (or Industrial), 24x36 Laguna around $6800.00, 48x48 like 11,000.00 new. Don't know what torque you need?

Same here, just started a couple of weeks ago???

We do it everyday, have not noticed excessive wear on tooling. We machine lots of 514 plate and water cut is much nicer on tools than flame cuts with at times surface hard and slag.

That'll work, sure appreciate the time you spend here helping folks out JP. Thanks

Thank you JP, that's easy enough for those. I'll see what I can do for the 180 radius serrations, that'll take some time? Thanks again Russell

I'm trying to mill these inverted radius serrations on a trunnion with a 4 axis mill, we don't have Mill 5 axis. The last three ops with the 82 Deg. mill, it seems to be close with xyz moves in backplot and verify, But when I post the angles, XY, seem correct but not the Z's? Also verify is not leaving flats evenly on the part? Don't know if this is a 5 axis project or not? Thanks for your time Russell 84402SolidSMALL2.Z2G

Well that's exactly what is being installed right now only it's a Mach 3, not excited about it, I prefer seeing chips fly. Thanks for the reply's

Anyone using Mastercam for a 5 Axis Waterjet or Plasma Machine? Thanks Russell

Someone should give you a better idea, but I think if you have round solid already and just want to cut a taper say on top, I would make your taper solid on a separate layer, then you can Boolean.

Age old problem, we have had more than one machine do this almost all the time. A little grease on the retention knob helps a little, only bad for holding keeping clean. Also we sprayed a coat of moly on the taper also helps a little. Never could figure out what brand of tool holders work best, but we do have some that just won't stick???? Figure something out other than buying an Okuma or Doosan let us know.