Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
Thank you Greg,
I will send this off the QC.
Are people using the latest greatest NVIDIA drivers for their Quadro cards, or are they using the ones suggested by the Solidworks website?
Is everyone using the driver suggested on the Solidworks website (http://www.solidworks.com/sw/support/videocardtesting.html)?
I have been getting this error (Unsupported model view matrix values) with X9, after having a session open for an hour or so.
I have a Quadro 2000D card.
It was suggested I update the video card driver to the most current.
Thank you for any input.
Hello
I have a generic Okuma post that needs line numbers. This post has been working very well for a long time, but it doesn't output line numbers for manual entries.
I have searched the forum and found some old post on adding line numbers to manual entries, but when I try it I get errors.
I am not a very experienced post editor, but thought, if this is simple enough, I would tackle it.
I believe this is the spot I need to modify;
pcomment$ #Comment from manual entry (must call pcomment2 if booleans)
pcomment2
pcomment2 #Comment from manual entry
spaces$ = 0
scomm$ = ucase (scomm$)
if gcode$ = 1006, *n, scomm$, e$
else, "(", scomm$, ")", e$
spaces$ = 1
any suggestions would be appreciated. I have quite a few manual entries and hand editing them is getting time consuming.
Thank you
Hello all,
When I use the 5 axis swarf function, the speed seems to be relative to the tip of the tool. I am sure that in most cases that is what I should want.
In this example, the top part of the cutter is going much faster than I would like. It is leaving a pretty rough finish. Is there anyway to make the speed more relevant to the center of my cut?
Thank you Ron,
I was trying to use the swarf path from the advancted multiaxis option. I didn't see that option the first time I tried the swarf through the multiaxis drop down.
Thank you, this helps allot.
Hello,
I am trying to use 5 Axis Multi Surf path to cut the side of a block. I want to use a flat endmill, and cut below the block (to make sure it gets cleaned up). The 5 axis swarf keeps a flat endmill from going below no matter where I place the floor or check surface.
Any thoughts?
Thanks for any advise
Update
(13 min, 17 sec
X3
Dell precision 670
Xeon 2.80 GHz
3.00 GB Ram
XP Pro 32 bit
Quadro FX 3450/4000 SDI)
We have added another 2.80 GHz processor, now my time is 12 min, 34 sec.
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.