2D dynamic stock

[So not a Guru]

Does 2D dynamic not allow stock models for stock selection?

I usually use Opti, but I'm reprogramming an old part & was trying not to have to completely re-invent the wheel.

[jwvt88]

No it does not. 

[crazy^millman]

You can use Optirough like 2D and get the benefit of stock models. I will make flat boundary surface of 2D shapes I want to cut with Optirough and then make the same boundary I would and then I am done.

[So not a Guru]

1 hour ago, 5th Axis CGI said:

You can use Optirough like 2D and get the benefit of stock models

I've done that in the past. I didn't want to have to change all of the programming and I didn't need the stock models for this job. This was just the 1st time I had ran across this, so I thought I'd ask.

 

[crazy^millman]

22 minutes ago, So not a Guru said:

I've done that in the past. I didn't want to have to change all of the programming and I didn't need the stock models for this job. This was just the 1st time I had ran across this, so I thought I'd ask.

 

Did you try air regions and other thing to help you use it?

[So not a Guru]

42 minutes ago, 5th Axis CGI said:

Did you try air regions and other thing to help you use it?

It wasn't necessary for this.

[Elvincnc]

On 3/5/2020 at 8:10 PM, 5th Axis CGI said:

You can use Optirough like 2D and get the benefit of stock models. I will make flat boundary surface of 2D shapes I want to cut with Optirough and then make the same boundary I would and then I am done.

You can show how to do it as an example, I really want to understand it