Post for Belmont SY-CNC3040T

[ZEUS LANCELOT G ZOLETA]

Hi All,

Has anyone here been able to create a program / post for Belmont EDM Drill 3040T in Mastercam, if so where can i buy for the post.?

Thanks

Zeus

[#Rekd™]

Contacting your reseller would be the first place to check.

[JParis]

Your reseller is the 1st place for that question...

The hosts of this site, In-House Solutions are a good source as is Postability...both will require you to go through your reseller

[Colin Gilchrist]

I built a Post for a SY-3040TG-5X when I was working at Methods Machine Tool. Not sure who you purchased the machine from, but the machine itself wasn't difficult to configure using the Generic Fanuc 5X Mill Post (although admittedly, I've been building Posts for a long time). Your best bet would be to contact your Reseller and have them build a Post to your requirements.