Op manager window size

[Mike Whitten CAD/CAM Contractors]

Hello,

 

Has anyone had the problem of not being able to size the op manager window to a reasonable size. The main problem is that sometimes I try to just make it a little taller and it gets taller than my whole Mastercam screen. If I then try to make it slightly shorter it gets far to short. IOW, it seems to have just two positions in the vertical direction.

 

Thanks for the help,

 

Mike

[Midwest]

I just grab the lower right corner with the mouse and stretch.

 

HTH

[Mike Whitten CAD/CAM Contractors]

I understand. When I do that it moves about 6"

 

Mike

[mross]

is it stretching outside the desktop (off the screen) if so it might be a video card setting.

 

what video card are u using?

 

might be able to reset position by running CNCReg.exe located in your mcam install folder.

 

HTH

[Mike Whitten CAD/CAM Contractors]

Geforce ti4200. ?

 

It has always worked OK in the past though.

 

I am having the same problem on two different computers. They both basically have the same video card though.

 

Thanks,

 

Mike

[Mike Whitten CAD/CAM Contractors]

I couldn't figure out the CNCreg thing. I will deal with it for a while more and see if anyone else has had the problem.

 

Thanks

[mross]

Run CNCReg.exe

 

On the settings tab find your installed product (ex. V9 Mill) and reset the position and coloumn width (bottom two reset buttons).

 

Not sure if that will work, but another grammer here changed his font and it screwed up some of his mcam dialog boxes and that fixed his problem.

 

HTH

[Mike Whitten CAD/CAM Contractors]

Mark.

 

It does not work. I will just deal with it for a while and then do a new install. It does not take too long anyhow.

 

Thanks for the help,

 

Mike

[Thad]

Mike,

 

Would doing a System Restore be of any help?

 

Thad

[Mike Whitten CAD/CAM Contractors]

I don't know? It sure sounds scary though?

 

I can re-install MC fairly fast though. It is an intermintant problem anyhow.

 

Thanks Thad.

 

Mike