Dumb Question

[GreggT]

Why is it that on the Define Tool>Parameters tab that the Rough XY is a percentage and the Finish XY is an actual distance????

 

Just whining, sorry. But consistency rules...

[DavidB]

Could it have somethiung to do with if you use Wear?

[DavidB]

Don't you find it easier to do Roughing as a % Eg:75% then a finish pass of say 0.1mm?

[GreggT]

No.

 

I think I'm going to go have a Foster's Oil Can and then I won't give a rip what the dialog boxes say.

[DavidB]

quote:

---

I think I'm going to go have a Foster's Oil Can

---

Thats about all Fosters is good for.

[GreggT]

So what exactly does one drink when they are in Australia?

[Thee Cutterman]

Victoria Bitter

 

Jack Daniels Jim Beam

 

and on a real good night

 

BULLET BOURBON

 

Now im going to have to go out for lunch

 

 

Cheer

Darren

[DavidB]

Dazza,

I'll join you for a Jimmy

 

[Lee.]

I am guessing it is so that you can load each roughing cutter to it's usual limits, usually given as a percentage of it's diameter, and then when you have roughed everything out, you are left with an even amount of material on the part, that when removed should give you an even finish.

 

HTH.

[Thee Cutterman]

David

 

justgotback J/K

 

 

Sorry mate. I did,nt check back before i went.

I have my last day at Tafe on the 2nd of December and my boss Myself and Smithy might go out for a drink.

 

I,ii give you a yell when he work out what is going on and i know you would be more than welcome. Speak to you soon

 

YEEE HAAAA 200 POSTS

 

Regards

Darren

[Greg Williams]

quote:

---

So what exactly does one drink when they are in Australia?

---

Tooheys Old and Margaret River red's.

But good ol' VB would be the most popoular

[Bruce Caulley]

VB tastes liks cats xxxx.

 

XXXX bitter or Bundy rum

 

 

Bruce the banana bender

[JayMan]

I'll drink anything but, I'm not joining anybody for a Jimmy... That just a'int right