quick question bout X

[MIL-TFP-41]

I have been playing around with the Control Definition stuff...and now when I post I get this error...

 

quote:

---

ERROR - WRITE NC OPERATION INFORMATION MUST BE ENABLED IN CONTROL DEFINITION - SET AND REPOST

---

I have looked high & low for this in the control definition, and have yet to find it. How do I get rid of this???

 

Also, for whatever reason, I am getting no spaces between blocks after I post...makes the program tough to read. I can't find this switch either.

 

Thanks!!

 

 

[edit]

 

I do find a switch that says "Output operation comments to NC" and it is CHECKED...so I shouldn't be coming up with this????

 

[/edit]

[kinglouie V]

try looking here..... See where it says write nc op info? Maybe that's it.

 

[kinglouie V]

did the same thing to me and threw me for

a loop until I found.

[MIL-TFP-41]

wow...sometimes things just stare me in the face and I miss it...good thing I am not at a strip club

[Jim Evans from CNC Software]

James,

 

Lou is correct with the setting in the CD. You are probably getting this because the post needs to read the parameters and the enable check box must be on for parameters to be written so the PST can read them.

 

The spaces value is in the NC OOUTPUT topic.