Mastercam X surface fillet

[Hao]

Whenever I try to fillet 2 or more surfaces to make a radius, I always get the error saying that no surfaces were found. I don't quite understand how I am suppose to select the surfaces because it tells me to select two sets of surfaces.

Any help would be appreciated.

Thanks in advance.

[Deb Rossing CNC Software]

As an example, let's work with a basic cube made of surfaces set in an Isometric GView. I want to fillet along the top edge of both the front and right sides of this cube along with the top surface (that gives me 3 surfaces to work with). I'll pick the front surface and right surface and hit the Green circle or Enter - that is "set 1". Then I'll pick the top surface and Enter - "set 2". Then I set my parameters and I get my fillets. Basically, you'd want to pick 'sets' of surfaces that make sense - in this instance, it makes sense to 'group' the sides as one set and the top as the other.

--Deb

[Ocean Lacky™]

Select 1st set (one or more surfaces), select 2nd set(one or more surfaces).

 

Surface Normals must point to the centerpoint of the desired fillet radius.

 

 

HTH

[pip]

How do you edit the flowlines of a surface, in X

[Todd Tracey from Fastech]

Check the "CAD Settings" page in configuration. Surface Density may be what you are asking for, not sure.