EASTEC 2007

[chris m]

Surprised not to see any threads on this; anybody going?

 

I'll be out there tomorrow milling around

 

C

[elbro]

I will be there also tomorrow.

[Charlie Pierson]

Wednesday for me

cp

[Guest]

quote:

---

Surprised not to see any threads on this; anybody going?

---

Wednesday for me.

 

 

BTW chris there was a thread in the OT forum 'bout 2 weeks ago

 

[Don S at Barefoot CNC South]

My old stomping grounds was Agawam, right over the bridge from W. Springfield. Now in SC

[rboucher]

I will be there Wednesday.

[Scott B]

Stop By and say "Hi" where located in building 5 booth 5245

[Guest]

You guys leave Peter home to watch the "office" again?

 

 

BTW, if anyone wants to meet up tomorrow, email me we can swap cell numbers. See if we can catch up

[Scott B]

No Pete's at the show today and Thhursday. The rookies only get one day at the show we have to watch over the cookie jar.

[P_Scott]

Sorry I'll miss everybody today. I did see a couple of our customers yesterday however. Wednesday is usually the busiest. I also got a chance to speak with Brett of In House and with the authors of the "Step By Step" 2D Mill book. There were a few new people too. "It's all good." If anyone here is planning on going tomorrow, stop by and say "hey" at the Mastercam booth, #5245. It's the short day, show ends at 3:00.

[Guest]

Stopped by chewed the fat with Scott B for a while, saw Steve and Neil, met Greg Mckay from CNC, ran into Charlie Pierson.

 

3 hour drive to to get there, should have taken 1-1/2 hrs because the omniscient Mass Turnpike Authority decides that doing work and shifting everything to 1 lane and then 3 miles down the road shifting traffic again because they want to do LINE PAINTING AT FREAKING RUSH HOUR!!!!!!!!!!!!

[Scott B]

John, Good talking with you yesterday. Brett wasn't at the booth when you stopped but did wanted to meet the "Infamous" post xxxxe himself. we filled him in so your OK.