Jump to content

Welcome to eMastercam

Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.

Use your display name or email address to sign in:

Rough restmill.


neil qwerty
 Share

Recommended Posts

We're machining some castings and I'm using an STL that has the the surfaces to be machined offset by 10 mm to represent the raw casting. I'm having problems with restmill plunging into areas in between cuts. If I use a ballnose cutter, this isn't a problem because it can center cut but I'd rather use a bullnose. Anybody have any suggestions? It would be nice to have the same entry options that are available in Surface, Rough, Pocket. This part is programmed in V9, I did had a look at the demo version of X2 but it doesn't seem to be much different.

 

Thanks,

Neil.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.

Join us!

eMastercam - your online source for all things Mastercam.

Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.

Follow us

×
×
  • Create New...