Extended Workshifts G54.1P1 etc...

[kenfromlodi]

How can I post out G54.1P1 etc for a Mori SH-63?

I have tried using higher numbers and it won't change. Do I have to edit the post?

Thanks for any help. It worked in MC9.

[crazy^millman]

Did you update the post or start with a new one?

[kenfromlodi]

its an updated post from 9.

Do you think thats the problem?

[Guest CNC Apps Guy 1]

It should not be a problem updating...

 

So you've changes the Offset number to something higher than 6? (6= G54.1P1)

[kenfromlodi]

I went to 20 hoping it would start working?

But no luck.

[Colin Gilchrist]

Does your post use miscellanous integer #1 to control the work offset output in addition to the "work offset" data entry field? You might need to use both a higher number (6 or above) and enable Misc. Int. #1 to a value of 1...

 

The pwcs postblock is where the logic for doing the extended series of work offsets exists. Try searching in your post for it.

 

HTH,

[kenfromlodi]

It does use Misc Int. to control and thats what I was changing. I have always been able to control from there in the past on g54-59, should I be changing something else?

[kenfromlodi]

Maybe I should ask "where would I change this at?"

Because I could be doing it wrong.

[kenfromlodi]

I am such a dork I was trying to change in the wrong spot! too much lathe programming lately. thanks for the help. its working now that im doing it right.