Deleting levels and Work Groups

[MotorCityMinion]

Version X.

 

How can I delete an entire level from the level manager?

 

How can I delete a workgroup from the Op's manager?

 

Off topic. I used "hide entities" to hide some surfaces. When I unhide them, they came back in stretched / extended, even though most of them were never trimmed. Can this be undone?

[Thad]

You don't delete levels. They're always there. You either use them or you don't. Remove all entities from them and delete the name assigned to them. That's as close as you're going to get.

 

To delete a group from the ops manager, right click-Groups-Delete.

 

I've never seen your hiding surface problem.

 

Thad

[Thad]

If you want to delete all entities on a particular level, click All-Level-select the desired level and then hit the delete key. This is not done from the levels manager though.

 

Thad

[Matthew Hajicek - Singularity]

I think what's going on is that when a surface gets trimmed, the system retains an untrimmed copy and blanks it. If you unblank all, you'll get the untrimmed surfaces too. With selective unblanking you should be able to get only the trimmed ones. That's why I never blank, I use different levels instead.

[Thad]

That's exactly what I thought Matt, but he said he was using hide, not blank.

 

Thad

[E3CADCAM]

MotorCityMinion, eh? Where you working?

[MotorCityMinion]

Not blanking peeps.

 

Motor is working in a toll and die shop, (That's right, Toll), although I have done blocks and cylinder head work for many years, primarily on 4 axis horizontals at Paramount and Galaxy. Where you be from?