Loss of OM Control - Start Point- Move Dynamic?

[J Coulston]

Searched but could not find the same problem.

 

On a 2D contour if I change the start point using start point - move dynamic. I loose control of the operation manager. Any click in the OM just beeps. I can save, continue drawing, rotate, ect just no OM. Starting a new tool path or minimizing and then maximizing will restore OM control.

 

Can anyone repeat?

[John13]

I just tried and and did not see what you are.

 

 

Is it file specific or can you do it in another file?

[J Coulston]

Any file new or existing.

[Span]

I have the same problem. If I open the configuration manager and click the check to close it the OM is working again.

[Dazz]

If you minimize and maximise mc, you can get around it that way.

[cadcam]

This is a known issue in X2mr2 if you say go and start another path like another contour then cancel it and go back and then you can regen.