Solid help

[Rakesh]

Hi everybody

I am drawing some solid model and in this one feature is .266 dia hole through and 82 deg c-sink on one end. I don't want to do by cut revolve the contour. What are the other technique except the revolve option when there is already hole in the solid and you want to give only 82 deg c-sink on one end. I was trying Cone primitive but some reason it get drawn only in top view and I want to draw in right side c-plane.

Any thought.

Thanks

[DavidSV]

Couldn't you do chamfer with a distance and angle?

[Surface]

Extrude/draft

[strabe]

Extrude the hole with the cut body option,then use the chamfer option "solid distance and angle"

[Rakesh]

Thanks David and Mr. Surface, both ways I never thought of, for doing this type of feature. I always did revolve cut so far.

Only thing for chmf and draft option is I have to calculate the distance and my case dia. .513 is given as the top dia of csink. There is no problem to calculate the distance but may be there is still better route out there.

Thanks

[JDowe]

create arcs at top and bottom do loft cut

 

or use arcs to create a lofted solid and do

a boolean remove