10mm Rad on a 6.35mm box

[Clayton aj M]

Would anyone tell me the steps to put a 10mm rad on a 6mm box and have it trimmed please.

 

Using Mastercam X

[Lars Christensen]

draw a box, draw a rad, trim trim

[3R!< W3NG3R]

Please explain better. The way I am seeing this, it wouldn't work. 10mm being bigger then the 6mm box.

[Storkman]

non-tanginal rad??????????

[Guest]

Something like this?

 

[Guest]

this is what i did.i created a 10 mm circle,drew to vertical lines at 3 mm each way off of x 0.drew a line a horizontal line at the intersection of the arc and vertical lines,drew a line perpindicular at x 0. anylyzed that distance from the circle to the horizontal line which was .0181. i then offset the 6mm square off of ech side and drew 45 deg line at the intersection of those lines. i then created an arc tanget to that 45 gegree line and trimmed it and rotated it 3 times at 90 degrees.i ll send it to ya if ya like

[Clayton aj M]

Sorry about that.

 

What i want to do is draw in either solids or surfaces. I need to draw a box that is 6.35mm square. and have the top of the box have a 5mm rad on it. Then trim them together so the rad is still a sphere shape with no flats on it.

[Clayton aj M]

Let me try it like this. If you can imagine the dome af a baseball cap ontop of the square box.

[3R!< W3NG3R]

try revolve. draw half the arc and revolve it around a center line.

[BernieT]

Like this ??

 

 

 

 

.

[Guest]

quote:

---

Like this ??

---

show off!