Creating curves on Surface Edges

[hancast]

Is there a way to get the create curves on surface edges to recognize arcs better. Everytime I do I check the fit arcs and lines, but I still end up with a lot of spline and arc combinations when it looks like it should make a complete arc.

[Hardmill]

Is there a way to get the create curves on surface edges to recognize arcs better. Everytime I do I check the fit arcs and lines, but I still end up with a lot of spline and arc combinations when it looks like it should make a complete arc.

 

Select all the splines and EDIT_SIMPLIFY to change to arcs.

 

 

 

 

 

 

 

 

 

 

 

PEACE

[K2csq7]

Go to Settings, Configuration, Tolerances. Click on the help button, it will explain all of the field definitions and you can make the changes to the individual tolerances as you deem necessary.

[DODGERFAN]

I DO IT THE SAME WAY HARD MILL SAID. WORKS GOOD

[Mic6]

Don't forget this button under "Create Curves" It will simplify for you after selection